XPress Stainless threaded T-piece FFF 42XRp3/4X42

Extension- gunmetal- R-thread, Rp-thread

Viega 2315

Elbow 90°- gunmetal- R-thread, Rp-thread

Viega awkward connection pipe with eccentric sleeve, for tolerance compensation for toilet drain connection, with lip seal.

Fittings with threads in acc. with DINEN 10226, Part 1, certified for drinking water in acc. with DIN 1988 and gas installations in acc. with TRGI 2008 (observe notes on the model), tested in acc. with DVGW worksheet GW 6 and GW 393.CertificatesGunmetal threaded fittings - DVGW-Reg.-No. DV-7401AO2957Threaded connectionsR-external thread, produced on site - hempen without roughening of the thread is possible.

Long nipple in gunmetal with R-thread. R: 12, L: 200 mm

XPress Stainless straight connector FF 42XRp5/4

The threaded pipe fittings of ISIFLO is produced of dezincification resistant brass alloy (DZR). Use for cold water or warm water (max 110 degrees centigrade), air, oil or gas. Running pressure up to 10 Bar. Cylindrical thread (ISO 228/1)

Henco connection tee with 2 x 3/4 eurocone and 1 x threaded end.

Tee, reducing,with internal threads

Viega 2216

Borma swivelspout with diverter 1/2 x 400 mm

Used with Roth alu-laserplus pipe and Roth tools

Viega 2216.1

Press connector system with press connectors made of copper and gunmetal tested in acc. with DVGW worksheet W 534 with DVGW test seal and pipes made of copper in acc. with EN 1057 in acc. with DVGW worksheet GW 392.Suitable for drinking water installations in acc. with DIN 1988.For dimensionally stable concealed and pre-wall installations of manifold and riser pipes in Viega component assembly.Press connectorsAll sizes with SC-Contur - connections, which remain unpressed become visible when the system is filled. The SC-Contur is certified and fulfils the requirements of DVGW worksheet W 534, point 12.14, connectors with forced leakage.During leakage tests with water, Viega guarantees the identification of unpressed connections in the pressure range 0.1 MPa-0.65 MPa, in the case of a dry leakage test with compressed air or noble gases from 22 hPa-0.3 MPa.MarkingGreen dot on the press connectionSealing elementsEPDM, black (ethylene-propylene-dien-monomer rubber), up to 110 °C